Table 3-3 Tcp/Ip Ethernet Setup Menu Fields - ZyXEL Communications Prestige 650ME User Manual

Prestige 650ME ADSL Bridge
FIELD
Primary DNS Server
Secondary DNS Server
Remote DHCP Server If Relay is selected in the DHCP field above then enter the IP
Follow the instructions in the following table to configure TCP/IP parameters for the Ethernet port.
FIELD
TCP/IP Setup
IP Address Enter the (LAN) IP address of your Prestige in dotted decimal
IP Subnet Mask Your Prestige uses a fixed subnet mask of 255.255.255.248.
RIP Direction Press [
Version Press [
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
IP Policies Create policies using SMT menu 25 (see the IP Policy Routing
Edit IP Alias The Prestige supports three logical LAN interfaces via its single
3-10
Table 3-2 DHCP Ethernet Setup Menu Fields
Enter the IP addresses of the DNS servers. The DNS servers
are passed to the DHCP clients along with the IP address and
the subnet mask.
address of the actual remote DHCP server here.

Table 3-3 TCP/IP Ethernet Setup Menu Fields

notation
SPACE BAR
] to select the RIP direction. Choices are
Both, In Only, Out Only or None.
SPACE BAR]
RIP-2B or RIP-2M.
used to establish membership in a Multicast group. The Prestige
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
SPACE BAR]
Press the [
to disable it.
chapter) and apply them on the Prestige LAN interface here. You
can apply up to four IP Policy sets (from twelve) by entering their
numbers separated by commas.
physical Ethernet interface with the Prestige itself as the gateway for
each LAN network. Press [
ENTER
press [ ] to for menu 3.2.1
DESCRIPTION
DESCRIPTION
to select the RIP version. Choices are RIP-1,
to enable IP Multicasting or select None
SPACE BAR
] to change No to Yes and
EXAMPLE
EXAMPLE
192.168.1.1
255.255.255.248
Both
RIP-1
None
2,4,7,9
No
(default)
Internet Access