Figure 2-8: 0-1 Vdc Or Rs 232 Digital Output Port - Teledyne AX300 Operating/Service Instructions Manual

Portable Oxygen Analyzer
When properly calibrated, the output signal generated by the analyzer is li-
near and proportional to the oxygen concentration.
If you requested Option-B (RS 232 digital output) at the time of purchase, a
digital RS 232 signal is output from the output port shown in Figure 2-8. Use the
optional RS 232 Interface Cable (P/N B-75555) available from Teledyne for
connection to a standard RS 232 port on a computer or other suitably equipped
digital device.
CAUTION: AX300 ANALYZER SHOULD ONLY BE CONNECTED TO AN
EN60601-1/IEC60606-1 APPROVED DEVICE.

Figure 2-8: 0-1 VDC or RS 232 Digital Output Port

RS232 signal output has been tested with Windows HyperTerminal. The setup
changes with different windows versions. If other software other than windows
HyperTerminal is used, consult with factory.
Windows 95 version
Baud:
Data:
Parity:
Stop bit:
Flow control:
Teledyne Analytical Instruments
2400
7
ODD
1
NONE
Operating Instructions
13