Table of Contents
Advertisement
SERVICE MANUAL
23JUL01
SM5766-1
Page
Important
35 of 96
It is necessary to push the AUTO-FOCUS BRACKET backward and forward to allow access
to the SCREWS on the LENS MOUNT ASSEMBLY.
7
Remove the 3 SCREWS from the LENS MOUNT ASSEMBLY.
8
Lift and remove the LENS MOUNT ASSEMBLY.
9
Remove the gray, red, and black wires from the AUTO FOCUS SWITCH ASSEMBLY.
Important
Keep the AUTO-FOCUS SWITCH LEVER that is connected to the AUTO FOCUS SWITCH
so you can install it on the new AUTO FOCUS SWITCH.
10
To disconnect and remove the AUTO FOCUS SWITCH, bend the LOCKING TAB on the
FOCUS MOTOR BRACKET until it is aligned with the hole in the AUTO FOCUS
SWITCH.
Installation for the AUTO-FOCUS SWITCH ASSEMBLY - Models 500 and
2000 PROJECTORS Only
Important
Align the 2 TABS on the AUTO-FOCUS SWITCH with the FOCUS MOTOR BRACKET,
checking that the end of the AUTO-FOCUS LEVER engages with the CYCLE SOLENOID
PLUNGER. After the AUTO-FOCUS SWITCH is in the correct position, bend the LOCKING
TAB to hold the AUTO FOCUS SWITCH in place.
1
Do the removal for the AUTO-FOCUS SWITCH in reverse order.
Removals and Installations
Hide quick links:
Advertisement
Table of Contents
