Removal For The Cycle Solenoid Assembly - Kodak Ektalite 500 Service Manual

SERVICE MANUAL
23JUL01

Removal for the CYCLE SOLENOID ASSEMBLY

SM5766-1
Page
19 of 96
CYCLE
SOLENOID
CYCLE
SOLENOID
PLUNGER
Warning
Dangerous Voltage
SCREW (2)
1 Disconnect the main power.
2 Do the removals for the LOWER
HOUSING ASSEMBLY and the
MOTOR.
3 Disconnect the 3 CONNECTORS on
the MAIN BOARD. It is not necessary to
disconnect the CONNECTORS next to
the LOWER LIGHT BAFFLE
ASSEMBLY.
4 Lift the MAIN BOARD up.
5 Cut and remove the necessary WIRE
TIES.
6 Disconnect the 2 violet wires from the
CYCLE SOLENOID on the SMALL
BOARD.
7 Pull the SMALL BOARD up.
A091_4014GCA
A091_4014GA
8 Remove the Torx SCREW from the
WORM PULLEY SHAFT.
9 Move the TAB on the WORM PULLEY
ASSEMBLY out of the MECHANISM
ASSEMBLY.
10 Lift and remove the WORM PULLEY
ASSEMBLY.
Removals and Installations