Photocell - Kodak Ektalite 500 Service Manual

SERVICE MANUAL
23JUL01

PHOTOCELL

SM5766-1
Page
51 of 96
Warning
Dangerous Voltage
8 Disconnect the main power.
PHOTOCELL
CIRCUIT BOARD
wratten
FILTER (2)
PHOTOCELL
POST (2)
MASK
PHOTOCELL
A091_4032GCA
HOUSING
Warning
Dangerous Voltage
1 Disconnect the main power.
2 Do the removal for the LOWER
HOUSING ASSEMBLY.
Important
It is necessary to use a FAN COVER TOOL.
3 Install the FAN COVER TOOL over the
FAN area and the LAMP MODULE.
4 Energize the projector.
5 Set the projector to the LO-LAMP
position.
6 Install and hold the AUTO FOCUS
TARGET SLIDE TL-3002 until it is fully
seated in the GATE MECHANISM.
A091_4032GA 7 Look through the PROJECTION LENS
hole and observe the focus light path
on the AUTO-FOCUS TARGET SLIDE
TL-3002. Check that the light path is
correct. If not, do the adjustment for the
FOCUS LIGHT PATH.
Adjustments