Replacing The Auto-Focus Switch Assembly; Installing The Auto-Focus Switch Assembly; Replacing The Focus Shaft Assembly - Auto Focus Models - Kodak CAROUSEL NEW LOOK PROJECTOR Service Manual

Replacing the AUTO-FOCUS SWITCH ASSEMBLY

AUTO FOCUS
MOTOR BRACKET
LOCKING
TAB
AUTO FOCUS
SWITCH LEVER
AUTO FOCUS SWITCH ASSEMBLY

Installing the AUTO-FOCUS SWITCH ASSEMBLY

Important
Align the 2 TABS on the AUTO-FOCUS SWITCH with the FOCUS MOTOR BRACKET, checking that the end of the
AUTO-FOCUS LEVER engages with the CYCLE SOLENOID PLUNGER. After the AUTO-FOCUS SWITCH is in the
correct position, bend the LOCKING TAB to hold the AUTO FOCUS SWITCH in place.
[1] Do the replacement procedure for the AUTO-FOCUS SWITCH in reverse order.

Replacing the FOCUS SHAFT ASSEMBLY - Auto Focus Models

Warning
Dangerous Voltage
[1] Disconnect the main power.
SM5440-1 – 18NOV97
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER
HOUSING ASSEMBLY.
[3] Remove the FOCUS KNOB.
[4] Remove the short, gray wire from the AUTO-
FOCUS DEFEAT SWITCH.
It is necessary to push the AUTO-FOCUS BRACKET
backward and forward to allow access to the SCREWS
on the LENS MOUNT ASSEMBLY.
[5] Remove the 3 SCREWS from the LENS MOUNT
ASSEMBLY.
[6] Lift and remove the LENS MOUNT ASSEMBLY.
[7] Remove the gray, red, and black wires from the
grey, red,
AUTO FOCUS SWITCH ASSEMBLY.
and black
wires
Keep the AUTO-FOCUS SWITCH LEVER that is
A091_4028GCA
A091_4028GA
connected to the AUTO FOCUS SWITCH so you can
install it on the new AUTO FOCUS SWITCH.
[8] To disconnect and remove the AUTO FOCUS
SWITCH, bend the LOCKING TAB on the FOCUS
MOTOR BRACKET until it is aligned with the hole
in the AUTO FOCUS SWITCH.
Replacements and Installations
Warning
Important
Important
21