Slide Obstruction In Slide Tray; Conditions For A Correct Transport Cycle - Kodak EKTAPRO 4020 Service Manual

SM 2547-1

Slide Obstruction in Slide Tray

Conditions for a correct transport cycle

- Check SLIDE LIFTER LEVER. In the up position, the alignment above the CENTER
HOUSING must be 3.8 mm (0.15 in.) with a tolerance of 0.2 mm (0.008 in.). If the
measurement is greater, replace the SLIDE LIFT LEVER.
- Check the CENTER HOUSING for damaged parts such as:
DRIVE RING
GEAR WHEELS
CODER DISK
Inspect whether the parts are complete. Are there damaged or broken teeth on the
wheels? If so, replace them.
Kodak AG, Stuttgart 5-29
Service Manual
03/98