Description Of Keys - Roland SOLJET SC-500 User Manual

Description of Keys

Top
Key Submenu
menu
—
—
—
—
—
PRINT
MODE
FORCE
— This switches on and off the sub power . When the
power is switched on, the POWER LED lights up.
— This detects the presence of material, and its dimensions,
and shows the printable or cuttable size on the display.
The SETUP LED flashes while detection of material
width is in progress. When setup finishes, the SETUP
LED lights up continuously.
Also press this key when removing the material.
— The [PAUSE] key pauses operation. The PAUSE LED
lights up while paused.
Pressing this key again cancels the paused state.
Holding down the [SETUP] key for about 1 second
while paused causes remaining data to be cleared and
cancels the material's setup state.
— This sets the present blade position (blade center) at the
printing or cutting start location (base point).
For more information, see "User's Reference -- Perform-
ing Cutting or Printing at the Desired Location."
— This sets an align point for correction when the material is
not straight.
The angle of the material, referenced from the base point,
is stored in memory. Any angle of 5 or less may be set.
This setting is valid only when cutting.
— This displays the [PRINT MODE] menu for setting
image quality.
This is used to specify the printing quality and unidirec-
tional or bidirectional printing.
Settings cannot be made while printing is in progress.
To exit the [PRINT MODE] menu screen, press the
[MENU] key or the [CLEANING] key or the [SETUP]
key.
For more information, see "Setup for Printing -- Setting
the Printing quality and Printing direction."
— This enters the menu for setting the conditions for
cutting.
You can set the values for blade force, cutting speed,
blade offset compensation, and tool movement speed
when raising the tool.
For more information, see "Display Menus Flowchart."
* When [COMMAND] on the display menu has been
set to [ENABLE], the program's settings for the
cutting conditions take priority.
To give priority to the cutting conditions set on the
machine, turn off the program settings, or set the
[COMMAND] menu to [DISABLE].
For more information about the [COMMAND] menu,
see the section "Descriptions of Menu Items -
Description of Menus."
Function
Description of Keys
Setting Default
range value
— —
— —
— —
— —
— —
[PRINT MODE]
[PRINT MODE]
FINE2
PHOTO
SUPER
[PRINT
FINE
DIRECTION]
FINE2
BI-DIREC-
NORMAL
TION
FAST
DRAFT
[PRINT
DIRECTION]
UNI-DIRECTION
BI-DIRECTION
[FORCE] [FORCE]
30 to 200 gf 50 gf
(In steps of 5 gf)
[SPEED] [SPEED]
1 to 60 cm/s 40 cm/s
(In steps of 1 cm/s)
[OFFSET] [OFFSET]
0 to 1.5 mm 0.25 mm
(In steps of 0.025 mm)
[UP-SPEED] [UP-SPEED]
1 to 60 cm/s 60 cm/s
(In steps of 1 cm/s)
77