Description Of Keys And Display Menus; Description Of Keys - Roland FJ-50 User Manual

4 User's Reference

4-5 Description of Keys and Display Menus

Description of Keys

Top
Key
menu
—
—
—
—
PRINT
QUALITY
HEAD
CLEANING
50
Submenu
— This switches on and off the sub power . When the
power is switched on, the POWER LED lights up.
— This detects the presence and the width of the material,
and displays the printable width.
The SETUP LED flashes while detection of material
width is in progress. When setup finishes, the SETUP
LED lights up continuously.
Also press this key when removing the material.
— The [PAUSE] key pauses operation. The PAUSE LED
lights up while paused.
Pressing this key again cancels the paused state.
Holding down the [SETUP] key for about 1 second
while paused causes remaining data to be cleared and
cancels the material's setup state.
— This sets the print-start location in the horizontal
direction (the direction of carriage movement). For
more information, see "2-6 Performing Printing --
Performing Printing at the Desired Location -- Specify-
ing a location in the left-right direction (the direction of
carriage movement)."
— This displays the [PRINT QUALITY] menu for setting
image quality.
This is used to specify the printing quality and unidi-
rectional or bidirectional printing.
Settings cannot be made while printing is in progress.
To exit the [PRINT QUALITY] menu screen, press the
[MENU] key or the [CLEANING] key or the [SETUP]
key.
For more information, see "2-6 Performing Printing --
Setting the Printing Mode."
This displays the [HEAD CLEANING] menu for
START
cleaning of the printing head. Before starting to print,
you can carry out a printing test to check the printing
TEST
quality.
You can perform cleaning while in any state. Note that
PRINT
[TEST PRINT] is not displayed while the printing is in
progress.
[TEST PRINT]: Performs a printing test within an area
of approximately 54 mm (2-3/16") by 18 mm (6/8"). If
there is a problem, then continue by carrying out
cleaning from the [START] menu.
[START]: Begins cleaning of the printing heads. After
cleaning, carry out a printing test to make sure there are
no problems.
For more information, see "2-5 Test Printing" and "3-3
Cleaning the Printing Heads."
Function
Setting Default
range value
— —
— —
— —
— —
[Printing [Printing
quality] quality]
PHOTO FINE
SUPER
[Printing
FINE
direction]
NORMAL
FAST BI-
DRAFT DIRECTION
[Printing
direction]
UNI-DIRECTION
BI-DIRECTION
— —