About The Printing/Cutting Area - Roland SOLJET SC-500 User Manual

About the Printing/Cutting Area

The printing/cutting area along the horizontal plane (the direction in which the carriage moves) is determined by the position of the pinch
rollers. The workable area spans the length between the two rollers, minus a margin of about 1.5 mm (about 0.06 in.) on both sides.
If [PIECE] has been selected and material length (the distance in the X direction as shown in the figure) is 2,000 mm, the area is the same
as when [EDGE] has been chosen.
10 mm
Pinch roller (left)
(3/8 in.)
Approx. 19.2 mm
(about 13/16 in.)
35 mm (1-1/8 in.)
(If the material configuration is [EDGE] or [PIECE].)
When crop marks are printed, the printing or cutting area in the area shown above is reduced by an amount equal to the size of the crop
marks (12.5 mm (0.5 in.) + 12.5 mm (0.5 in.)).
12.5 mm
The area
(0.5 in.)
shown above
Pinch roller
(left)
12.5 mm
(0.5 in.)
Crop mark
Max.: 1346 mm (53 in.)
Material
Max.: 24998 mm
(984-1/8 in.)
Approx. 1.5 mm
(about 0.06 in.)
* The arrows in the figure indicating the X and Y directions indicate
respectively the positive directions of the X axis and Y axis.
The area when
crop marks are
printed
Crop marks
When [PIECE] is
selected
Printing/cutting area
Approx. 1.5 mm 10 mm
Pinch roller (right)
(3/8 in.)
(about 0.06 in.)
The area shown above
Printing or cutting area when crop marks are printed
12.5 mm
(0.5 in.)
Crop mark
User's Reference
60 mm
(about 2-1/8 in.)
19.2 mm (13/16 in.)
35 mm (1-1/8 in.)
(If the material configuration
is [EDGE] or [PIECE].)
Printing/cutting
coordinates origin (0, 0)
Default area
Pinch roller (right)
12.5 mm
(0.5 in.)
Printing/cutting
coordinates origin (0, 0)
75