When Operations Are Finished - Roland SOLJET SC-500 User Manual

When Operations Are Finished

NOTICE
Even when not in use, keep the machine in an environment where the temperature is 5 to 40 ˚C (41 to 104 ˚F) and
the humidity is 20 to 80 % (no condensation). In particular, be careful to make sure not to expose the machine to
high temperatures of 40 ˚C (104 ˚F) or more.
When operations are finished, move the sheet loading lever toward the back of the unit to raise the pinch rollers.
The pinch rollers may be deformed if allowed to remain in the lowered state.
1
If the SETUP LED is lighted, press the [SETUP] key.
Hold down for about 1 second.
The SETUP LED goes out
3
Remove the blade holder from the cutting carriage.
(1) Loosen the tool
securing screw
5
Press the [POWER] key to switch off the power.
The carriage moves to the standby position and the head is capped.
If the carriage is already at the standby position, no movement takes place.
The POWER LED goes out
(2) Remove the blade holder
Carriage
When Operations Are Finished
2
Move the sheet loading lever toward the back of the
unit and remove the material.
4
Remove the blade.
Blade holder
Blade
Sheet loading lever
Press the push-pin
Standby position
43