Printing With Crop Marks - Roland SOLJET SC-500 User Manual

Printing with Crop Marks

1
Press the [MENU] key and [
following screen appear on the display.
3
Use the [ ] key to select [ENABLE], then press the
[ENTER] key.
CROP MARK
DISABLE ENABLE
* Setting [CROP MARK] to [ENABLE] makes the
output area 25 mm (1 in.) narrower.
If you used the program to enable or disable crop marks, then crop marks are printed or not printed according to the
program settings. The setting made with the control panel for the machine takes effect only in cases where the program
does not specify that crop marks are enabled or disabled.
Crop marks are printed bidirectionally. If you have changed the material to a different type or changed the head height,
adjust bidirectional printing. For more information about bidirectional printing, see "User's Reference - Make Correc-
tions for Printing."
] key to make the
MENU
CROP MARK
2
Press the [ ] key to make the following screen
appear on the display.
CROP MARK
DISABLE DISABLE
4
Send the printing data from the computer.
Three crop marks are automatically printed on the left
and right areas at the front edge of the material.
User's Reference
Rear
Front
Crop marks
61