Performing Cutting Or Printing At The Desired Location - Roland SOLJET SC-500 User Manual

User's Reference

Performing Cutting or Printing at the Desired Location

Set the print or cutting start position (base point) to the desired location.
1
Load material and install a blade, then press the
[SETUP] key.
3
Press the [BASE POINT] key.
The BASE POINT LED lights up
To release the starting location that has been set...
• Set a new starting location in a different location.
• Press the [SETUP] key to cancel the setup for the material (making the SETUP LED go out).
56
2
Use the arrow keys to align the blade with the new
printing or cutting start location (base point).
When an align point has been set,
it is released if the [BASE POINT]
key is pressed.
Align with
the center
of the blade
installed on
the cutting
carriage.