Replacing The Cutter Blade - Roland SOLJET SC-500 User Manual

Maintenance

Replacing the Cutter Blade

Do not touch the tip of the blade
with your fingers.
Doing so may result in injury, and the
cutting performance of the blade will be
impaired.
1
Remove the blade holder from the cutting carriage.
(1) Loosen the tool
securing screw
3
Replace with a new blade.
Push-pin
Blade holder
New
blade
48
(2) Remove the blade holder
2
Remove the old blade.
Blade holder
Old
blade
4
(1) Loosen the tool securing screw on the cutting
carriage.
(2) Support the tool-securing screw from below and
install the blade holder. Insert the blade holder
until the collar is flush with the carriage.
(3) Tighten the tool securing screw until the blade
holder is secured in place.
Loosen
Tool securing screw
Press the push-pin
Cutting carriage
Tighten