To Perform Long Printing/Cutting - Roland SOLJET SC-500 User Manual

User's Reference

To Perform Long Printing/Cutting

When performing printing or cutting over a length of 1.5 m (60 in.) or more, first feed out the required length of material. Then follow
the steps below to load the material.
1
Pull out the material from the roll and pass it through
the unit.
Rear
Roll material
*Use material that is wider by 50 mm (2 in.) or
more than the width of the printing or cutting to
be performed.
3
Move the sheet loading lever all the way to "LOAD,"
then close the front cover.
Sheet loading lever
When moved partway,
only the right-hand
pinch roller descends.
Data cannot be output
while in this state. To
secure the material in
place, move all the way
to "LOAD."
5
Press the [MENU] key and [
following screen appear on the display.
7
Use the [ ] key to select [ENABLE], then press the
[ENTER] key.
PREFEED
ENABLE ENABLE
70
] key to make the
MENU
PREFEED
2
Position the left- and right-hand pinch rollers at the
locations shown in the figure.
25mm (1 in.)
or more
*Make sure the pinch rollers are positioned above
the grit rollers.
4
At [SELECT SHEET], choose [ROLL] or [EDGE],
then press the [SETUP] key.
SETUP SHEET
ROLL EDGE PIECE
6
Press the [ ] key to make the following screen
appear on the display.
PREFEED
DISABLE ENABLE
8
Send the printing/cutting data from the computer.
When using the [PREFEED] function, set
[EDGE SENSE] to [ENABLE].
Depending on the program, the [PREFEED]
function may not work.
25mm (1 in.)
or more