HP NonStop TMF Programming Manual page 785

Error and Warning Messages
8013 Tape volume IDs for the two parallel copies are not different.
The tape volume IDs for two parallel copies specified in a tape DEFINE clause
are not unique.
8014 The attribute ZART-TKN-DEFINEATTRNAME was specified for the
tape DEFINE ZART-TKN-DEFINENAME and it is not allowed.
The specified attribute is not allowed in a tape DEFINE clause.
8015 VOLUME SCRATCH specified for input in the tape DEFINE ZART-
TKN-DEFINENAME.
VOLUME SCRATCH is not allowed as an input specification in a tape DEFINE
clause.
8016 Value for the tape DEFINE attribute DENSITY conflicts with the
DENSITY parameter.
An erroneous DENSITY attribute was specified in a tape DEFINE clause.
8025 Tape record is too short (Length: ZART-TKN-RECORDLEN).
The tape record is too short. This could be caused by corruption of the tape,
dirty tape drive heads, faulty tape drives, or a software bug in the dump or
restore program.
8026 Tape record is not even (Length: ZART-TKN-RECORDLEN).
The tape record is not even. This could be caused by corruption of the tape,
dirty tape drive heads, faulty tape drives, or a software bug in the dump or
restore program.
8027 Tape record checksum is bad.
The tape record checksum is invalid. This could be caused by corruption of the
tape, dirty tape drive heads, faulty tape drives, or a software bug in the dump or
restore program.
8028 Tape record type is unknown.
The tape record type is invalid. This could be caused by corruption of the tape,
dirty tape drive heads, faulty tape drives, or a software bug in the dump or
restore program.
HP NonStop TMF Management Programming Manual—540140-008
Archive Tape Errors and Warnings
7-57