HP NonStop TMF Programming Manual page 202

Commands and Responses
Tokens in Command Buffer
ZTMF-TKN-Fileset
specifies the name of an audited file to be recovered, or the name of a file of
filenames (each filename in the specified file being the name of an audited file to
be recovered).
This token can also contain a wild card (value asterisk (*), length 1). If the wild card
is specified, the token must be the only instance of this token in the command
buffer. The wild card specifies that all files on the physical volume(s) designated by
the ZTMF-TKN-ToPhysVol or ZTMF-TKN-WherePhysVolIs token are to be
recovered.
The name of a file of filenames must be enclosed within angle brackets (< and >),
and it cannot contain wildcards.
Each line in a file of filenames contains a vol-pattern.subvol-pattern.filename-
pattern starting in the first column. A filename does not have to be fully qualified (if
necessary, the defaults specified by the ZTMF-TKN-FilesetDefault token are used
to expand it). Comments beginning with a minus sign in column 1 and blank lines
are allowed. Any characters following a filename pattern are comments.
This token is optional. When specifying names of audited files to be recovered,
multiple occurrences of this token are allowed. When specifying the name of a file
of filenames, however, only one occurrence of this token is allowed. The names of
two different files of filenames can be specified in ZTMF-TKN-Fileset and ZTMF-
TKN-NotFileset tokens within the same command buffer.
ZTMF-TKN-NotFileset
specifies the name of an audited file not to be recovered regardless of its redo-
needed or undo-needed status, or the name of a file of filenames (each filename in
the specified file being the name of an audited file not to be recovered).
The name of a file of filenames must be enclosed within angle brackets (< and >),
and it cannot contain wildcards.
Each line in a file of filenames contains a vol-pattern.subvol-pattern.filename-
pattern starting in the first column. A filename does not have to be fully qualified (if
necessary, the defaults specified by the ZTMF-TKN-FilesetDefault token are used
to expand it). Comments beginning with a minus sign in column 1 and blank lines
are allowed. Any characters following a filename pattern are comments.
This token is optional. If this token is present, however, the ZTMF-TKN-Fileset
token must also be present.
When specifying names of audited files not to be recovered, multiple occurrences
of this token are allowed. When specifying the name of a file of filenames,
however, only one occurrence of this token is allowed. The names of two different
files of filenames can be specified in ZTMF-TKN-Fileset and ZTMF-TKN-NotFileset
tokens within the same command buffer.
HP NonStop TMF Management Programming Manual—540140-008
5-138
RECOVER FILES