Default Setting Mode - SATO CG2 Series Operator's Manual

Section 3: Operation and Configuration

3.8 DEFAULT SETTING MODE

When default setting mode is selected and executed in Operation Setting mode (refer to Section 3.5
Operation Setting Mode), the printer will reset to the default setting (factory preset) as listed below.
No. Items to be reset
1 Offset (V, H)
2 Pitch Offset
3 Cut Offset
4 Dispensing Offset
5 Tear-Off Offset
6 Label Size
7 Print Speed
8 Print Darkness
9 Sensor Type
10 Kanji Code
11 Paper End Search
12 Zero Slash
13 Proportional Pitch
14 Initial Feed
15 Auto Feed
16 Operation mode
17 Interface
18 Tear Off Waiting Time
19 Head Check Range
20 RFID Mode
*1. To be connected by Port1024 and Port1025 (2 port connections) or Port 9100 (1 port connection)
Note:
LAN and Wireless LAN setting items cannot be reset to factory default even with the default setting mode.
Page 3-16
Default value
Vertical = 0 dot, Horizontal = 0 dot
0 dot
0 dot
0 dot
0 dot
Pitch 4800 dot x Width 448 dot [203 dpi]
Pitch 4800 dot x Width 672 dot [305 dpi]
75 mm/sec (3 Inches/sec)
5A
Gap
JIS
Roll
Enabled
Enabled
Disabled
Disabled
Continuous - (No setting)
Tear Off - (No setting)
Cutter Mode 1 (Head position)
Dispenser Mode 1 (Head position)
RS-232C Baud rate=19200 bps, Data bit=8 bit, Parity=None,
Stop bit=1 bit, Protocol=Protocol for driver
LAN Protocol for driver (ENQ response mode) *1
USB - (No initial setting)
1000ms
Normal range (Entire print area)
Disabled
CG2 Series Operator Manual