SATO CG2 Series Operator's Manual page 36

Section 3: Operation and Configuration
3.4 FACTORY TEST PRINT MODE (cont'd)
3.4.1 Output Data of the Factory Test Print
The output data of the Factory Test Print shows the internal operating parameters of the printer.
These output data are printed in three parts, each with the printing area of 60mm [2.36"] (Width) x 80mm
[3.15"] (Pitch), Standard.
First print-out (Settings)
No.
1 Model
2 Firm Ver
3 Firm Date
4 Font Version
5 CONT/USB Serial
6 Life Counter
7 Head Counter1
8 Head Counter2
9 Head Counter3
10 Cutter Counter
11 Head Check
12 Thermistor
13 Sensor Type
14 Sensor Level Low
15 Sensor Level High
16 Sensor Slice Level
17 Pitch Offset[VR3]
18 Option Offset[VR3]
19 FROM1 CHECK SUM
20 LAN(WLAN) CHECK
SUM
Page 3-10
Print Item
Printer model name
Printer F/W version
Printer F/W creation date
Font version
USB serial No.
Life counter
Head counter 1
Head counter 2
Head counter 3
Cutter counter
Head check result
Print head temperature
Sensor type
Average minimum value of
pitch sensor
Average maximum value of
pitch sensor
Pitch sensor slice level
Print start position
Option stop position
Printer F/W: Font: Check
sum
LAN(WLAN) F/W check sum
Contents of the print data
CG208TT(*), CG212TT(*)
CG208DT, CG212DT
*: "T" is printed for thermal
transfer print.
"D" is printed for direct
thermal print.
32.**.**.**
YY.MM.DD
**.**(R)
********
*.* Km
*.* Km
*.* Km
*.* Km
*******
OK / NG
***
I-Mark
Gap
Gap (Wrist Band)
None
*.* V
*.* V
*.* V
±30 DOT [203dpi]
±45 DOT [305dpi]
±30 DOT [203dpi]
±45 DOT [305dpi]
(B)**** (P)****
(F)**** (A)****
(B)**** (P)**** (A)****
CG2 Series Operator Manual