Font Download Mode - SATO CG2 Series Operator's Manual

3.7 FONT DOWNLOAD MODE

In this mode, the printer is set to download fonts from the host computer. Remember to set the printer to the
correct active interface to be used for the data transfer.
Status of printer in Font Download Mode
Start-up
No
Reception
from interface?
Yes
Reboot
command
reception?
No
No
Font data
reception?
Yes
Download
Download
completion
Reboot and start in normal mode
Online
Notes:
• Use the selected interface for PC connection.
The downloaded font goes into effect when you restart the printer.
•
• When not receiving reboot command, manually reboot the printer and restart in normal operation mode.
• Ensure that the printer is in the "Wait to receive data" status (blinking red light) before you manually turn off
the printer.
• During the process of downloading, if ON LINE (POWER) indicator responds differently from above
mentioned procedure, an error may have occurred. Please refer to Section 3.11 Error Occurrence While
Downloading for details.
CG2 Series Operator Manual
Activation via operation
setting mode or download
command.
At the start of download
mode
Yes
Wait to receive data
Start receiving data/
Receiving data
Writing to flash ROM
At the time of download
completion
Printer turns off
Printer turns on again
Online mode
Section 3: Operation and Configuration
ON LINE (POWER) indicator responses
Off (while pressing FEED/LINE)
Change to solid red light after
release of FEED/LINE
(From step 5 of Operation
Setting Mode. )
Solid red light
Blinking red light
Green→Red (Lights in turn)
Solid green light
Blinking green light
No light
Solid red light
Solid green light
Solid green light
Page 3-15