Connecting To Ac Power; Ethernet Network Connection To Dhd Controller - Runco LightStyle LS-100d Installation & Operation Manual

Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD
Controller; see Figure 3-12. For more information about configuring and using this
connection, refer to Network on page 58.
RS-232 RS-232
To Accessory Box To Accessory Box
HDMI 3 HDMI 3
HDMI 4 HDMI 4
to Ethernet
Hub, Router
or Gateway
Figure 3-12. Ethernet Network Connection to DHD Controller
Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the LS-100d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
Lightstyle™ Series LS-100d Installation/Operation Manual
Display Control Display Control
IR IR
HDMI Out HDMI Out
To Display To Display
HDMI Out HDMI Out
Ethernet
Audio Only Audio Only
1 Transmit Data +
2 Transmit Data -
3 Receive Data +
6 Receive Data -
29
Installation

Connecting to AC Power