Connecting To Ac Power; Ethernet Network Connection To Dhd Controller - Runco VideoXtreme VX-11d Installation & Operation Manual

Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD
Controller; see Figure 3-21. For more information about configuring and using this
connection, refer to Network on page 75.
RS-232 RS-232
To Accessory Box To Accessory Box
HDMI 3 HDMI 3
HDMI 4 HDMI 4
to Ethernet
Hub, Router
or Gateway
Figure 3-21. Ethernet Network Connection to DHD Controller
Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the VX-11d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
Runco VX-11d Installation/Operation Manual
Display Control Display Control
IR IR
HDMI Out HDMI Out
To Display To Display
HDMI Out HDMI Out
Ethernet
Audio Only Audio Only
1 Transmit Data +
2 Transmit Data -
3 Receive Data +
6 Receive Data -
39
Installation

Connecting to AC Power