Connecting The Dimension Digital Controller To The Projector - Runco Signature Cinema SC-30d Installation & Operation Manual

Runco recommends using the RS-232 communication link
Note
between the SC-30d/SC-35d projector and the Dimension Digital
Controller. However, display control using HDMI CEC control
messages is also possible. For more information on this capability,
please contact Runco Technical Support.
Figure 3-13 shows how to connect the Dimension Digital Controller to the projector.
Dimension Digital Controller
Figure 3-13. Connecting the Dimension Digital Controller to the Projector
Runco SC-30d/SC-35d Installation/Operation Manual
3D SYNC 3D SYNC TRIGGERS TRIGGERS
1 1 2 2 3 3
Component / SCART Component / SCART
Y Y Video 1 Video 1 Video 2 Video 2
Pb Pb Video 3 Video 3
Pr Pr
DisplayPort r r DisplayPort HDMI 2 HDMI 2
HD2 HD2
RS232 PRIMARY
RS232 PRIMARY
Pri. Display Control Sec. Display Control Sec. Display Control
IR IR
HDMI Out
To Sec. Display
HDMI 4 HDMI 4 HDMI 6 HDMI 6 HDMI 8 HDMI 8 HDMI Out HDMI Out HDMI Out
Ethernet Ethernet
Audio Only Audio Only
To Pri. Display
SECONDARY 3D Sync Out
SECONDARY Out Sync 3D
37
Installation