Connecting An External Ir Receiver To The Projector; Connecting 12-Volt Trigger Output To External Theater Equipment - Runco XtremeProjection X-200i Installation & Operation Manual

Installation
Connecting an External IR
Receiver to the Projector
Connecting 12-Volt
Trigger Output to External
Theater Equipment
If infrared signals from the remote control cannot reach the projector due to excessive
distance or obstructions such as walls or cabinet doors, you can connect an external IR
receiver to extend the range of the remote control. See Figure 3-15.
(3.5-mm, mini
phono plugs)
POWER POWER
POWER POWER
LED STATUS LED STA T T TUS
STATUS TUS A A STA T T
WIRED REMOTE
REMOTE WIRED
I I II II
12V TRIGGER 12V TRIGGER
TRIGGER TRIGGER 12V 12V
3D SYNC 3D SYNC
HDMI 1 HDMI 1
SYNC SYNC 3D 3D
1 1
Figure 3-15. External IR Receiver Connection
If you are installing an X-200i/CineWide with AutoScope, connect the AutoScope lens
motor to a 12-volt trigger output on the X-200i as shown in Figure 3-8.
Similarly connect other 12-volt trigger-activated equipment (such as retractable screens or
screen masks) to the other trigger output; see Figure 3-16.
Retractable Screen or other
12-volt trigger-activated
device
Figure 3-16. 12-Volt Trigger Output Connection
ISSUE ISSUE
ISSUE ISSUE
A A
LED LED
COMPONENT 1 COMPONENT 1
RS-232 RS-232 USB USB
1 1 COMPONENT COMPONENT
RS-232 RS-232 USB USB
HDMI 2 HDMI 2 RGB RGB Y Y
HDMI HDMI 2 2 HDMI HDMI RGB RGB Y Y
COMPONENT 2 COMPONENT 2
2 2 COMPONENT COMPONENT
Sleeve = Ground
Tip = +12V
34 Runco X-200i Series Installation/Operation Manual
IR Sensor
IR Repeater
Pb Pb
Pb Pb
3.5-mm
mini plug
POWER POWER
POWER POWER
WIRED REMOTE WIRED REMOTE
REMOTE REMOTE
I II
12V TRIGGER
TRIGGER 12V
3D SYNC 3D SYNC
SYNC SYNC 3D 3D
Remote Control
ISSUE ISSUE
ISSUE ISSUE
LED STA LED STATUS T T TUS A A
TUS A A STATUS STA T T LED LED
RS-232 RS-232
WIRED WIRED
RS-232 RS-232
HDMI 1 HDMI 1 HDMI 2 HDMI 2
1 1 HDMI HDMI 2 2 HDMI HDMI