Turning On The Power - Runco Signature Cinema SC-30d Installation & Operation Manual

Installation
3.9

Turning on the Power

1. Power up your source components.
2. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see Figure 3-16).
3. Turn on the main power switch at the rear of the Dimension Digital Controller.
4. Press the ON button on the remote control (or the ON/STANDBY (
Dimension Digital Controller front panel) to turn on the system. The vacuum
fluorescent display on the Dimension Digital Controller front panel briefly displays
"Initializing System," followed by "Starting SC-30d/SC-35d."
5. When the display is ready for use, the fluorescent display indicates the active source,
input resolution/frame rate and aspect ratio/screen; for example:
SC-30d/SC-35d
16:9/1
Aspect Ratio/Screen
6. When the projector is turned on, the Active 3D Emitter turns on as well. The LEDs
display a red moving pattern while the emitter attempts to acquire a 3D signal and
until a signal is found.
If the emitter searches for a signal for longer than 60 seconds, a signal is assumed to
not be present.
Searching for 3D Sync Signal
7. Upon finding a 3D signal, all LEDs turn blue. Once the LEDs indicate a 3D signal, the
3D glasses can be used to experience 3D. For more information on using the Active
3D Glasses, refer to Using the 3D Glasses on page 98.
Current
Source
HDMI 1
1080i/60
1080p/60
Input Resolution/Frame Rate
50 Runco SC-30d/SC-35d Installation/Operation Manual
) button on the
3D Sync Signal Found