Adjusting The Picture Orientation - Runco Signature Cinema SC-30d Installation & Operation Manual

Installation
3.11
Adjusting the Picture
Orientation
By default, the SC-30d/SC-35d is configured for a "floor/front" installation, in which the
projector is installed upright and in front of the screen. If it is installed behind the screen
and/or mounted on a ceiling, you must change the picture orientation. To do this:
1. On the Dimension Digital Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
You must enter a passcode to access the Service menu.
Note
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Installation.
5. Select Orientation, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match
the installation method.
52 Runco SC-30d/SC-35d Installation/Operation Manual