Installation
3.2
Quick Setup
Table 3-1 gives a quick overview of the SC-30d/SC-35d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
2
Install primary projection lens
Install anamorphic lens mounting assembly (optional)
3
Mount the projector
4
Mount the Dimension Digital Controller
5
Connect the Dimension Digital Controller to the projector
6
Connect other external equipment to Dimension Digital Controller
(optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
7
• 12-volt trigger-activated equipment (retractable screens or
screen masking)
• External IR repeater
• Network hub, router or gateway (Ethernet)
Connect signal sources to the Dimension Digital Controller
8
Connect the Active 3D Emitter to the Dimension Digital Controller
9
10
Connect system components to AC power
Apply power to the projector
11
Adjust primary lens: projected image size (zoom), position (shift)
12
and focus
For rear-screen and/or ceiling-mount installations, select the
13
proper picture orientation
14
Use Image Alignment controls to fine-tune image geometry
Install and adjust secondary anamorphic lens (optional)
15
Display calibration: adjust the following for each Dimension
Digital Controller input and display mode (resolution/frame
rate); save settings when finished:
• Aspect ratio
16
• Brightness
• Contrast
• Color temperature and white balance
Prepare Active 3D Glasses for use and test with 3D source mate-
17
rial
Procedure
• Color level
• Tint
• Input position
20
Runco SC-30d/SC-35d Installation/Operation Manual
For Details, Refer
to page...
21
28
30, 40
34
35
36
38
43
49
49
50
24, 51
52
53
55
64 through 83
98