Auto Power-Off Function - Icom IC-E7 Instruction Manual

11
OTHER FUNCTIONS
D Cloning using a personal computer
Data can be cloned to and from a personal computer (Mi-
crosoft ® Windows ® 98/98SE/Me/2000/XP) using the optional
CS-P7
CLONING SOFTWARE
. Consult the CS-P7
CLONING CABLE
file for details.
CAUTION: Be sure to turn OFF the transceiver when con-
necting the cloning cable, otherwise cloning op-
erations cannot be performed.
D Cloning error
NOTE: DO NOT push any key on the sub-transceiver dur-
ing cloning. This will cause a cloning error.
When the display appears as below, a cloning error has oc-
curred.
In such a case, both transceivers automatically return to the
clone standby condition and cloning must be repeated.
WFMAM - DUP
VOL PRIO P SKIP
LOW 1
Microsoft and Windows are registered trademarks of Microsoft Corporation in
the U.S.A. and other countries.
61
and the optional OPC-478/478U
CLONING SOFTWARE
T SQL DTCS ATT
MR
5 9

■ Auto power-off function

The IC-E7 can be set to automatically turn OFF after a spec-
HELP
ified period in which no operation is performed.
120 min., 90 min., 60 min., 30 min. and OFF can be specified.
The specified period is retained even when the transceiver is
turned OFF by the auto power-off function. To cancel the
function, select "OFF" in step e below.
qWhile pushing and holding [FUNC], push and hold
[SQL] ( •
ATT SET
w Rotate [DIAL] to select "AP OFF."
• Turn the expanded set mode ON for selection. (p. 39)
SET
SET
eWhile pushing and holding [FUNC], rotate [DIAL] to select
the desired time or to turn the function OFF.
r Push [SQL] (
ATT
EXPANDED SET MODE
USING
) for 1 sec. to enter set mode.
[DIAL]
WFMAM - DUP
VOL PRIO P SKIP
LOW 1 5
After 1 sec.
WFMAM - DUP
SCAN
S.MW
VOL PRIO P SKIP
LOW 1 5
) to exit set mode.
•
SET
T SQL DTCS ATT
MR
9
T SQL DTCS ATT
MR
9