Priority Watch Operation - Icom IC-E7 Instruction Manual

8
PRIORITY WATCH

■ Priority watch operation

D D Memory channel watch and memory scan watch
q Select VFO mode, then set an operating frequency.
• TX channel can also be selected.
wPush [V/M] (
•
SKIP
lect the channel(s) to be watched.
For memory channel watch:
Rotate [DIAL] to select the desired memory channel.
For memory scan watch:
Push and hold [CALL] (
type selection condition to select the scan type, then push
[CALL] ( •
MODE SCAN
eWhile pushing and holding [FUNC], push and hold
) for 1 sec. to enter set mode.
[SQL] ( •
ATT SET
r Rotate [DIAL] to select "PRIO."
SCAN
SCAN
S.MW
S.MW
SET
SET
43
) to enter memory mode, then se-
.
S MW
) for 1 sec. to enter scan
•
MODE SCAN
) again to start memory/bank scan.
[DIAL]
WFMAM - DUP
T SQL
VOL PRIO P SKIP
LOW 1 5 9
After 1 sec.
WFMAM - DUP
T SQL
VOL PRIO P SKIP
LOW 1 5 9
tWhile pushing and holding [FUNC], rotate [DIAL] to turn
the priority watch ON.
• Select "BELL" if the priority beep function is necessary.
WFMAM - DUP
VOL PRIO P SKIP
LOW 1 5
Priority ON
y Push [SQL] (
• "PRIO" indicator appears.
• The transceiver checks the memory/bank channel(s) every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 41)
• During priority watch
WFMAM - DUP
T SQL
DTCS ATT
VOL PRIO PSKIP
LOW 1 5
Monitors VFO frequency
MR
for 5 sec.
• During priority watch with priority beep
WFMAM - DUP T SQL
DTCS ATT
VOL PRIO PSKIP
MR
LOW 1 5
Emits beep and blinks "S" indicator when a signal is re-
ceived on a memory (bank) channel.
uWhile pushing and holding [FUNC], push [SQL] (
to cancel the watch.
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP
MR
LOW
9 1
Priority beep ON
• ) to exit set mode and start the watch.
ATT SET
WFMAM - DUP
DTCS ATT
MR VOL PRIO
9 LOW 1
Pauses on a memory (bank) channel
when a signal is received.
DTCS ATT WFMAM - DUP
MR VOL PRIO
9 LOW 1
T SQL DTCS ATT
MR
5 9
T SQL DTCS ATT
PSKIP MR
5 9
T SQL DTCS ATT
PSKIP MR
5 9
• )
ATT SET