Icom IC-E7 Instruction Manual page 70

10
SET MODE
D D Auto power OFF
The transceiver can be set to automatically
turn OFF after a specified period with a beep when no key
operations are performed.
30 min., 1 hour, 1.5 hours, 2 hours and OFF (default) can be
specified. The specified period is retained even when the
transceiver is turned OFF by the auto power OFF function. To
cancel the function, select "OFF" in this set mode.
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
30 min. timer
D D Scan pause timer
Selects the scan pause time. When receiving
signals, the scan pauses according to the scan pause time.
• 2–20 : Scan pauses for 2–20 sec. on a received signal,
and is selected in 2 sec. steps. (default: 10 sec.)
• HOLD: Scan pauses on a received signal until it disap-
pears. Rotate [DIAL] to resume manually.
WFMAM - DUP T SQL DTCS
VOL PRIO P SKIP MR
LOW 9
1 5
Scan pauses for 10 sec.
57
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
2 hrs. timer
ATT WFMAM - DUP T SQL DTCS
VOL PRIO P SKIP MR
LOW 9
1 5
Scan pauses until signal
disappears
D D Scan resume timer
Selects scan resume time. Scan resumes
after the specified period when the received signal disap-
pears.
• 0 : Scan resumes immediately when the received
signal disappears.
• 1–5 : Scan pause 1–5 sec. after the received signal
disappears. (default: 2 sec.)
• HOLD: Scan pauses on the received signal even if it dis-
appears. Rotate [DIAL] to resume manually.
WFMAM - DUP
VOL PRIO P SKIP
LOW 1
Scan resumes after 2 sec.
D D Scan stop beep
Turns the scan stop beep function ON and
OFF (default).
When the function is activated ("ON" is selected), a long beep
will sound each time a signal is received during scan.
WFMAM - DUP
ATT
VOL PRIO P SKIP
LOW
1
No beep is sound when
receiving a signal
T SQL DTCS ATT WFMAM - DUP
MR VOL PRIO P SKIP
5 9 LOW 1
Scan resumes manually
T SQL DTCS ATT WFMAM - DUP
MR VOL PRIO P SKIP
LOW
5 9 1
A long beep is sound when
receiving a signal
T SQL DTCS ATT
MR
5 9
T SQL DTCS ATT
MR
5 9