Full/Band/Programmed Scan - Icom IC-E7 Instruction Manual

7
SCAN OPERATION

■ Full/band/programmed scan

q Select VFO mode with [V/M] (
• Select the desired frequency band with [BAND] (
sired.
w Set the squelch to the point where noise is just muted.
ePush and hold [CALL] (
scan type selection condition.
r Rotate [DIAL] to select the desired scanning type.
• "ALL" for full scan; "BAND" for band scan, "PROGxx" for pro-
grammed scan (xx= 0 to 24; programmed scan edges numbers
only displayed)
[DIAL]
SCAN
SCAN
S.MW
SET
35
• . ), if necessary.
SKIP S MW
), if de-
•
TS LOCK
) for 1 sec. to enter
•
MODE SCAN
• Full scan selection
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW
1 5 9
• Band scan selection
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
• Programmed scan selection
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW
1 5 9
Selectable between " 0" to "24"
if programmed
tPush [CALL] (
•
MODE SCAN
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
• To stop the scan, push [CALL] (
• During full/band scan
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW
1 5 9
About the scanning steps: The selected tuning step in
each frequency band (in VFO mode) is used during scan.
Push Push and hold
) again to start the scan
• ).
MODE SCAN
• During programmed scan
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW
1 5 9
Dual operation