Programmed Scan Operation - Icom IC-E7 Instruction Manual

QUICK REFERENCE GUIDE

■ Programmed scan operation

50 channels of memories in 25 pairs are used to specify
scanning ranges for programmed scan operation. The pro-
grammed scan scans between "xxA" and "xxb" (xx=00 to 24)
channels. Therefore, before operating the programmed scan,
different frequencies must be programmed into the "A" and
"b" channels.
D D Programming scan edges
A start and stop frequency must be programmed into a pair
of "xxA" or "xxb" channels.
1. Setting frequency
In VFO mode, set the desired operating frequency and mode.
• When " " indicator is displayed, push [V/M] (
the VFO mode.
2. Selecting a scan edge channel "A"
Push and hold [V/M] (
sec. to enter select memory write
mode (1 short and 1 long beep
sound), then rotate [DIAL] to select
the desired scan edge channel "A."
• " " indicator and scan edge channel
number blink.
VII
• .
SKIP S MW
) for 1
• .
SKIP S MW
WFMAM - DUP T SQL
VOL PRIO P SKIP
LOW
1 5
3. Writing a memory channel
Push and hold [V/M] (
sound.
• Scan edge channel "b" is automatically selected when continuing to
push [V/M] (
SKIP
• After programming is completed, the display returns to VFO indica-
tion.
4. Selecting a scan edge channel "b"
Push and hold [V/M] (
sec., then rotate [DIAL] to select the
desired scan edge channel "b."
• " " indicator and scan edge channel
number blink.
) to select
• When the scan edge channel "b" is already selected at step 3, con-
tinuing to push [V/M] (
5. Writing a memory channel
DTCS ATT Push and hold [V/M] (
sound.
• The next scan edge channel "A" is automatically selected when con-
MR
9
tinuing to push [V/M] (
• After programming is completed, the display returns to VFO indica-
tion.
) for 1 sec. until 3 beeps
• .
SKIP S MW
• . ) after programming.
S MW
• . ) for 1
SKIP S MW
WFMAM - DUP
VOL PRIO P SKIP
LOW
) after programming, skip this step.
• .
SKIP S MW
) for 1 sec. until 3 beeps
• .
SKIP S MW
• . ) after programming.
SKIP S MW
T SQL DTCS ATT
MR
1 5 9