Panel Description - Icom IC-E7 Instruction Manual

r PRIORITY WATCH INDICATOR (p. 43)
Appears when priority watch is in use.
t LOW POWER INDICATOR (p. 16)
➥ "LOW" appears when the low output power is selected.
➥ No indicator appears when the high output power is se-
lected.
y S/RF METER
➥ Shows the relative signal strength while receiving sig-
nals. (p. 13)
➥ Shows the output power level while transmitting. (p. 16)
u SKIP INDICATORS (p. 39)
➥ "SKIP" appears when the selected memory channel is
set as a skip channel.
➥ "PSKIP" appears when the displayed frequency is set
as a skip frequency.
i MEMORY CHANNEL NUMBER INDICATOR
➥ Shows the selected memory channel number. (pgs. 12,
24)
➥ "C" appears when the call channel is selected. (p. 12)
➥ "L" appears when the lock function is active. (p. 18)
o MEMORY INDICATOR (pgs. 12, 24)
Appears when memory mode is selected.
!0 AUTO WRITE CHANNEL INDICATOR (p. 38)
Appears when auto write channel is selected.

PANEL DESCRIPTION

!1 ATTENUATOR INDICATOR (p. 15)
Appears when the RF attenuator is in use.
!2 TONE INDICATORS
➥ "T" appears while the subaudible tone encoder is in use.
(p. 21)
➥ "T SQL" appears while the tone squelch function is in
use. (p. 45)
➥ "DTCS" appears while the DTCS squelch function is in
use. (p. 45)
➥ "S" appears with the "T SQL" or "DTCS" indicator
while the pocket beep function
in use. (p. 45)
!3 DUPLEX INDICATORS (p. 19)
"DUP" appears when plus duplex, "–DUP" appears when
minus duplex (repeater operation) is selected.
!4 OPERATING MODE INDICATOR (p. 14)
Shows the selected operating mode.
• FM, WFM and AM are available.
1
1
is
(with CTCSS or DTCS)
4