Scan Edges Programming - Icom IC-E7 Instruction Manual

■ Scan edges programming

Scan edges can be programmed in the same manner as
memory channels. Scan edge frequencies are programmed
into scan edges, 00A/00b to 24A/24b, in memory channels.
q Push [V/M] (
) to select VFO mode, if necessary.
• .
SKIP S MW
w Set the desired frequency:
➥ Select the desired band with [BAND] (
➥ Set the desired frequency with [DIAL].
➥ Set other data
(e.g. offset frequency, duplex direction, sub-
audible tone frequency, etc.)
ePush and hold [V/M] (
SKIP
memory write mode.
• 1 short and 1 long beeps sound.
• " " indicator and memory channel number blink.
rRotate [DIAL] to select the desired programmed scan
edge channel from 00A to 24A.
[EXAMPLE]: Programming 145.300 MHz into scan edge 03A.
Push
S.MW
WFMAM - DUP DTCS ATT
T SQL
VOL PRIO P SKIP MR
LOW
1 5 9
• ).
TS LOCK
, if desired.
) for 1 sec. to enter select
• .
S MW
for 1 sec. Rotate
WFMAM - DUP WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP VOL PRIO P SKIP
MR
LOW 1 5 9 LOW 1
t Push and hold [V/M] (
• 3 beeps sound
• The other scan edge channel "b," 00b to 24b, is automatically
selected when continuing to push [V/M] (
gramming.
yTo program a frequency for the other pair of scan edges,
00b or 24b, repeat steps w and t.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
S.MW
Push for 1 sec.
S.MW
WFMAM - DUP
T SQL DTCS ATT T SQL
VOL PRIO P SKIP
MR
LOW
5 9 1 5
SCAN OPERATION
• . ) for 1 sec.
SKIP S MW
• .
SKIP S MW
[DIAL]
SCAN
S.MW
SET
DTCS ATT WFMAM - DUP DTCS
T SQL
MR VOL PRIO P SKIP MR
LOW
9 1 5 9
7
) after pro-
7
ATT
36