I Full/Band/Programmed Scan - Icom IC-91A Instruction Manual

I Full/band/programmed scan

q Push [VFO]
to select VFO mode
• Select the desired frequency band with [BAND], if desired.
w Set the squelch level.
eWhile pushing and holding [SCAN](2), rotate [DIAL] to se-
lect the desired scanning type.
• "ALL" for full scan; "BAND" for band scan, "PROG-xx (or scan
name if programmed)" for programmed scan (xx= 0 to 24; pro-
grammed scan edges numbers are only displayed), "DUP" (ap-
pears only when duplex operation is set) for duplex scan.
[DIAL]
.
• Full scan selection
146 010
148 800
• Band scan selection
148 800
• Programmed scan selection
Selectable between " 00" to "24"
if programmed.
r To start the scan, release [SCAN](2).
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
• Push [VFO] to stop the scan.
• During full/band scan
148 800
About the scanning steps: The selected tuning step in
each frequency band (in VFO mode) is used during scan.
Duplex scan function: Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
Scan name selection
148 800
Scan name
Scan name is not displayed during a programmed scan.
SCAN OPERATION
• During programmed scan
148 800
P01 P01
148 800
P01 P01
Scan edge number
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
75