Table of Contents
Advertisement
Assembly
the mill/drill was fully assembled at the factory
except for the handwheel handles.
use a flat-head screwdriver to attach the
handwheels handles, as shown in Figure 8.
handwheel handles
Figure 8. handwheel handles attached.
Model G0754 (Mfg. Since 1/13)
Joining Drill chuck
& Arbor
the joining of the drill chuck and arbor is intended
to be semi-permanent. if you would like to use
a different chuck in the future, we recommend
obtaining a new arbor.
Important: Do NOT install the drill chuck and
arbor into the spindle until AFTER the test run.
To join the drill chuck and arbor:
1.
use acetone or lacquer thinner to clean the
drill chuck and arbor mating surfaces, espe-
cially the bore.
2.
retract the chuck jaws completely into the
chuck.
3.
insert the small end of the arbor into the
chuck.
4.
hold the assembly by the arbor and tap the
chuck onto a block of wood with medium
force, as illustrated in Figure 9.
Figure 9. tapping drill chuck/arbor on block of
wood.
5.
Attempt to separate the drill chuck and
arbor —if they do separate, begin again from
Step 1.
-15-
Advertisement
Table of Contents
