Table of Contents
Advertisement
Tilting Headstock
1.
disConneCt MAChine FroM poWer!
2.
Loosen the three locking hex nuts (see
Figures 13–14).
hex nut
Figure 13. tilt locking hex nut
(one on each side of head).
hex nut
Figure 14. hex nut underneath headstock.
3.
using the scale shown in Figure 13 as a
guide, swivel the headstock and re-tighten
the three hex nuts to secure it.
4.
re-tighten the hex nuts before connecting to
power.
Model G0754 (Mfg. Since 1/13)
tilt
scale
Table Travel
the table travels in two directions, as illustrated
in Figure 15:
•
X-axis (longitudinal)
•
y-axis (cross)
these movements are controlled by handwheels
and the X-axis power feed.
X-Axis or Longitudinal Travel
(Left & Right)
Figure 15. the directions of table movement.
Graduated Index Rings
the handwheels have graduated scales that are
used to determine table movement in 0.001" incre-
ments, with one full revolution equalling 0.100".
use the thumb screw shown in Figure 16 to adjust
the graduated dial for a relative starting point.
thumb screw
Figure 16. graduated dial and thumb screw.
Y-Axis or
Cross Travel
(In & Out)
graduated dial
-21-
Advertisement
Table of Contents
