Table of Contents
Advertisement
Lubricating Mill/Drill
GEARBOX MUST
BE FILLED WITH OIL!
OIL MAY NOT BE
SHIPPED WITH MACHINE!
Refer to Lubrication Section
for Correct Oil Type.
the headstock oil reservoir must have the proper
amount of oil in it before the mill/drill can be oper-
ated for the first time.
damage caused by running the mill/drill without oil
in the reservoir will not be covered under warran-
ty. refer to the Lubrication section, beginning on
Page 28, for details on how to check and add oil.
-16-
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 32.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
Make sure the headstock has the proper
amount of oil before performing the Test
Run and Spindle Break-In. Otherwise, the
headstock components may be damaged
and void the warranty. Refer to Page 29 for
detailed instructions.
To test run the machine:
1.
Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2.
Make sure all tools and objects used during
setup are cleared away from the machine.
3.
Connect the machine to the power source.
4.
rotate the spindle switch to FWd to turn the
machine ON.
5.
Listen to and watch for abnormal noises or
actions. the machine should run smoothly
with little or no vibration or rubbing noises.
— strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
6.
turn the machine OFF.
Model G0754 (Mfg. Since 1/13)
Advertisement
Table of Contents
