Headstock Movement; Rotating Headstock; Raising/Lowering Headstock - Grizzly G0754 Owner's Manual

Headstock
Movement
the headstock moves in the following ways:
• rotates 360° around the column.
• travels up and down the column.
• tilts 90° left and right relative to the table.
Tools Needed
Wrench 22mm ................................................... 1
Wrench 24mm ................................................... 1

Rotating Headstock

1. disConneCt MAChine FroM poWer!
2. Loosen the two hex nuts shown in Figure 11.
hex nuts
Figure 11. hex nuts that lock headstock on
column.
3.
Make sure the headstock and cords can
move unobstructed, then manually rotate the
headstock around the column.
4.
re-tighten the hex nuts before connecting to
power.
-20-

Raising/Lowering Headstock

1.
disConneCt MiLL FroM poWer!
2. Loosen the two hex nuts shown in Figure 11.
3. use the z-axis crank shown in Figure 12 to
adjust the headstock height.
Qty
z-Axis
Crank
4. re-tighten the hex nuts before connecting to
power.
Figure 12. z-axis crank.
Model G0754 (Mfg. Since 1/13)