Table of Contents
Advertisement
SEcTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.
If you are not experienced with this type
of machine, WE STRONGLY REcOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-18-
manual
bEFORE
To complete a typical operation, the operator
does the following:
1.
examines workpiece to make sure it is suit-
able for cutting.
2.
puts on protective gear.
3.
securely clamps workpiece to the table.
4.
With the machine disconnected from power,
installs correct cutting tool.
5.
Adjusts headstock height above the table.
6.
Without the machine running, checks the
range of table or spindle movement neces-
sary for the operation to make sure the setup
is safe and correct.
7.
selects the correct spindle speed.
8.
Connects the machine to power and turns it
ON.
9.
uses downfeed controls or table controls to
perform the cutting operation.
10. turns the machine OFF and waits for the
spindle to completely stop before removing
workpiece.
Model G0754 (Mfg. Since 1/13)
Advertisement
Table of Contents
