Fluke 5700A Series II Service Manual page 155

815 Outside Entry Limits
816 Magnitude Too Large For Calibrator
817 Magnitude Too Small For Calibrator
818 Frequency Too Large For Calibrator
819 Frequency Too Small For Calibrator
820 Calibrator Cannot Source That Value
821 V Limit Outside Calibrator Ability
I
822 Limit Outside Calibrator Ability
823 Cannot Adjust Frequency To <<= 0 Hz
824 Offset Not Allowed Now
825 Scale Not Allowed Now
826 Ohms Reading Set Too High
827 Ohms Reading Set Too Low
828 Cannot Use External Sense Now
829 Cannot Use Phase Shift Now
830 Cannot Use Phase Lock Now
831 Cannot Use 2-ire Comp Now
832 Could not Do Default Wideband Output
833 Bad Selector For Set/Get
834 Cannot Boost This Output Mode
835 Cannot Use Ext Sense On Selected Range
836 Cannot Use 2 Wire Comp On Selected Range
837 Cannot Lock This Range
838 Cannot Set Clock, Rear Switch
839 Cannot Fmt EEPROM, Rear Switch
I
840 llegal Output Post For Current
841 No 5725 Available For Selected Output
842 Not A Valid Wideband Flatness Point
843 Wideband Flatness Cal
844 Report String Too Long
845 Cannot Store, Rear Switch
846 Range Calibration
847 Magnitude Too High For Range Cal
848 Magnitude Too Low For Range Cal
I
tem
I
n NORMAL
I
n NORMAL
I
s Not Active
I
n NORMAL
I
s Not Active
Maintenance 4
Fault Codes
4-17