Current Shunt (80J-10); Ac/Dc Current Probe (Y8100) - Fluke 8062A Instruction Manual

RESPONSE.......................................
VOLTAGE RANGE .........................
MAXIMUM INPUT VOLTAGE......
INPUT CAPACITANCE ..................
TEMPERATURE RANGE
Operating.........................................
Storage ............................................
HUMIDITY ......................................
OUTPUT CONNECTOR..................

6-9. Current Shunt (80J-10)

The Model 80J-10 Current Shunt extends the current measuring capability of
the DMM to 10 amps continuous (20 amps for periods not exceeding one
minute) dc to 10 kHz at an accuracy of 0.25% in excess of the voltmeter
accuracy.
SHUNT .............................................
ACCURACY (18 C to 28 C)
DC to 10 kHz ..................................
10 kHz to 100 kHz ..........................
TEMPERATURE COEFFICIENT ...
INDUCTANCE.................................
OVERLOAD.....................................
CONNECTS TO ...............................
CONNECTORS ................................

6-10. AC/DC Current Probe (Y8100)

The Fluke Y8100 AC/DC Current Probe is a clamp-on probe that is used
with a voltmeter, multimeter, or oscilloscope to read dc, ac or composite (ac
on dc) current measurements. The jaws on the Y8100 are designed to clamp
Accessory Information

Current Shunt (80J-10)

kHz to 700 MHz
Responds to the peak value of an
input and is calibrated to read rms
value of a sine wave.
0.25 to 30V rms
30V rms, 200V dc
Approximately 3 pF
+10 C to +35 C
40 C to +75 C
<90% R.H
Fits standard 0.75-inch dual banana
connectors
10 amps at 100 mV
0.25%
Rising to 1 dB at 100 kHz typical
0.005%/ C
18.3 nH in series w/0.01 shunt
Up to one minute at 20A with a 1/4
duty cycle for recovery after currents
between 10A and 20A.
3/4 inch center banana jacks
5-way binding posts (red and black)
6
6-9