Fluke 8062A Instruction Manual page 48

8062A
Instruction Manual
Continuity (
1. Select range.
2. Set switch in
for resistance function.
3. Ensure that other switches are out.
4. Press the
visible continuity:
Press the
audible continuity:
(Press again to disable both):
5. Connect the test leads as shown.
6. Ensure that the device being measured
contains no electrical energy. Heed the input
overload limits (Table 2-2), and connect the
test leads to the circuit.
7. Observe the display for visible continuity
indicated by the bar.
Or listen for tone indicating audible continuity.
2-26
)
button once to enable
button again to enable
Figure 2-16. Continuity (
Continuity
Button
Low (-)
) Operation
High (+)
BEEEEP
dy21f.eps