Table of Contents
Advertisement
741B/743B
Users Manual
Recording Min and Max Measurements
You can set the display to record and show the
maximum and minimum readings. Min and Max
readings are always undamped, even if Dampen is
On. Press the
More Choices
the
softkey to turn on this feature. Press the
Min Max
key to reset the Min Max registers. Press the
softkey again to revert to the normal display.
Min Max
The following figure shows the display with Min Max
on:
84
softkey twice, then press
gj55s.eps
Running a Preloaded Task (743B only)
Press the
More Choices
softkey appear, then press
tasks (procedures) downloaded from a host
computer. Tasks are 743B calibrator configurations,
saved with a procedure name, for example the type
and manufacturer of a specific transmitter. A task
configures the calibrator for transmitter calibration
with all the calibration parameters (source and
measure functions, 0% and 100% levels, test
strategy) predefined.
While the task is controlling the calibrator, the
softkey becomes
Continue
Clearing Memory
In Setup mode, highlight the
and press
to clear all the memory:
Saved results
Min Max data
Log data sets (Model 743 only)
A confirmation message appears so that you do not
inadvertently erase the memory.
softkey until the
Tasks
to view the list of
Tasks
.
Continue Task
choice
Clear Memory
Advertisement
Table of Contents
