Table of Contents
Advertisement
Preserving Battery Life
An optional
Auto Battery Save
calibrator off after a selected idle time. The default
setting for
Auto Battery Save
is
, the
Battery Save
On
upper right corner of the display. The setting is
preserved after you turn off the power. Auto Battery
Save works the same when using the battery
eliminator. Turn on the
Auto Battery Save
follows:
1. Press
.
2. Press
to highlight
.
Save
3. Press
or the
4. Press u to highlight
5. To accept the timeout period shown on the
display, you can finish here. Press
Setup mode and do not go on to step 6.
6. To change the timeout period, press d to
highlight the timeout period following
.
Save Timeout
feature turns the
is
. When
Off
Auto
symbol shows in the
feature as
following
Off
Auto Battery
softkey.
Choices
, then press
.
On
to exit
Done
Battery
Documenting Process Calibrator
7. Press
or the
8. Enter your choice of timeout period in minutes
(accepted range: 1 to 120 minutes).
9. Press the
softkey.
Done
10. Press the
softkey or
Done
mode.
Using the Optional Battery Eliminator
Caution
To avoid damage to the calibrator, use
only Fluke Model BE9005 Series Battery
Eliminator, available from your Fluke
representative.
Where ac power is available, you can use the
optional Fluke Model BE9005 Battery Eliminator to
conserve battery power. When the battery eliminator
is used, the battery is internally disconnected, and
can be removed from the calibrator. The battery
eliminator does not charge the battery.
Setting Up the Calibrator
softkey.
Choices
to exit Setup
23
Advertisement
Table of Contents
