Simulating Rtds - Fluke 741B User Manual

741B/743B
Users Manual

Simulating RTDs

Refer to Table 6 for information about RTD
(Resistance-Temperature Detector) types
supported by the calibrator.
Connect the calibrator to the instrument under test as
shown in Figure 21. Proceed as follows to simulate
an RTD (Resistance-Temperature Detector):
54
Note
1. If necessary, press
2. Press until the select RTD type display is
showing.
3. Press the or keys followed by
select the desired RTD type.
4. Enter the temperature you want to simulate as
prompted by the display, then press
for SOURCE mode.
to
.