Table of Contents
Advertisement
OK
Figure 14. Using a Jumper Correctly
8. If necessary, you can change between C or F
WRONG
9. If necessary, you can change between
gj14f.eps
Documenting Process Calibrator
temperature units in Setup mode as follows:
a. Press
.
b. Press the
Next Page
c. Use the
and
keys to move the cursor
to the parameter you which to change, then
press
or the
choose a setting for that parameter.
d. Press
or
to move the cursor to the
desired setting.
e. Press
to go back to the
display.
f.
Press the
softkey or
Done
mode.
IPTS-68 Temperature Scale
procedure is the same as steps a through f
above.
Using Measure Mode
softkey twice.
softkey to
Choices
to exit Setup
or
ITS-90
in Setup mode. The
39
Advertisement
Table of Contents
