Extreme Networks BlackDiamond X8 Series Hardware Installation Manual page 80

9 Use a # 2 Phillips screwdriver to lock each handle into place.
When a locking screw is fully tightened, the yellow band around the screw head is completely
hidden.
Caution
Be careful to avoid over-torquing and stripping the screw heads.
Figure 58: Locking the Module into Place
Install I/O Module Blanks
Switches are shipped with a reinforcement shipping cover installed over all the I/O module slots. You
need a #2 Phillips screwdriver to install a module blank.
After you have installed all the I/O modules for your system configuration, you must install module
blanks in all remaining unoccupied slots.
Caution
All unoccupied slots in a BlackDiamond X8 series switch must have module blanks correctly
installed to ensure conformance to FCC requirements as well as to maintain adequate airflow
through the switch.
1 Check the condition of the EMI gaskets along the front panel edges of the blank, and confirm that
the gaskets are not damaged.
BlackDiamond X8 Series Switches Hardware Installation Manual
BlackDiamond X8 Maintenance Procedures
80