Extreme Networks BlackDiamond X8 Series Hardware Installation Manual page 16

Figure 4: BDXA-10G48X I/O Module
1 = 10-gigabit Ethernet ports
In the default configuration for the BDXA-10G48X module, all ports:
•
Are added to the default VLAN as untagged.
•
Inherit the properties of the default VLAN (for example, protocol type and VLAN ID).
The BDXA-10G48X module has the following LEDs:
•
Module status (STAT)
•
Module diagnostics (DIAG)
•
Port status
For information about the LEDs and their activity on the BDXA-10G48X modules, see
BDXA-40G24X I/O Module
The BDXA-40G24X I/O module has 24 unpopulated QSFP+-based 40-gigabit Ethernet ports. Each
installed QSFP+ optical module can operate as a single 40-gigabit port or as four 10-gigabit ports. In
40G port mode, the module provides 24 ports; if all ports are operating in 10G mode, the module
provides 96 ports.
When the ports are operating in 40-Gbps mode, the port numbers increment by 4. For example, the
first four ports in the top row would be numbered (from left to right) 1, 5, 9, and 13. Other port numbers
are displayed in ExtremeXOS as "not available." When a port is configured to operate in 10-Gbps mode,
all four port numbers associated with that physical port are displayed as being available. The default
mode for the ports is 40-Gbps operation.
When a port is configured to operate in 10-Gbps mode, all four port numbers associated with that
physical port are displayed as being available. The default mode for the ports is 40-Gbps operation. To
configure a port for 10-Gbps operation, use the
configure ports partition
command.
BlackDiamond X8 Series Switches Hardware Installation Manual
2 = LEDs
BlackDiamond X8 Series Modules and Fans
I/O Module LEDs.
16