I/O Modules - Extreme Networks BlackDiamond X8 Series Hardware Installation Manual

Table 4: LEDs on the BDX-MM1 Management Module (continued)
Label/Function
FM
Fabric module status
Link
(on Management port)
Activity
(on Management port)
Auxiliary port
(unlabeled)

I/O Modules

The switch has the following I/O modules available:
•
BDXA-10G48X
•
BDXA-40G24X
•
BDXA-40G12X
•
BDXA-10G48T
No configuration information is stored on the I/O modules; all configuration information is stored on the
management modules.
When a switch is powered on, the software generates a default configuration for any slots that contain
I/O modules. The default configuration allows the I/O module ports to participate in the VLAN named
default. The default configuration for the I/O module is not preserved unless you explicitly save the
configuration to NVRAM.
You can configure parameters of an I/O module after it is installed, or preconfigure a slot for a certain
type of module and configuration. The preconfigured information is applied to the module after it is
inserted. If you preconfigure a slot for a specific module type and then insert a different type of module,
the inserted module reverts to its default configuration.
See the ExtremeXOS Concepts Guide and the ExtremeXOS Command Reference Guide for feature-
specific information related to BlackDiamond X8 series modules.
BDXA-10G48X I/O Module
The BDXA-10G48X I/O module has 48 unpopulated SFP+-based 10-gigabit Ethernet ports.
BlackDiamond X8 Series Switches Hardware Installation Manual
Color/State Meaning
Amber/steady The fabric module is running diagnostics or has a fault condition.
Check the FM LEDs on the fan trays at the rear of the chassis. (See
LEDs for the BlackDiamond X8 Series Fabric
Off All the fabric modules are operating normally.
Green Link is up.
Off Link is down.
Amber Packet activity is occurring.
Off No packet activity is occurring.
N/A For future development
BlackDiamond X8 Series Modules and Fans
Modules.)
15